DEVICE TYPE: DPA-4.5 in-line fractional analyzer

• Measured parameters: fractional composition (beginning and end of boiling, percentage / temperature of distillation) to control the production process and control the composition during mixing
• Sample type: gasoline, diesel fuel, aviation and jet fuel, raw materials for processing for petrochemical processes (naphtha), fuel oils, intermediate oil products, hydrocarbons with a maximum final boiling point not exceeding the limit of thermal decomposition
• Compliance with standards: fully complies with ASTM D86, EN ISO 3405, GOST 2177
• Measuring Range: 0-100% / 0-400 ° C
• Accuracy: according to MVI
• Measurement cycle time: 35-45 min (full distillation cycle), 10-15 min (accelerated distillation cycle)
• It is entered in the State registry of SI of the Russian Federation No. 57636-14

INSTRUMENT TYPE: in-line refractometer UR-X1

• Measured parameters: refractive index or concentration (recalculation according to the user's scale)
• Measurement range: 1.32-1.54 (with the possibility of narrowing to delta N = 0.02)
• Accuracy: ± 0.3 percent of the measuring range (± 0.0001 typical)
• Measurement Cycle Time: Continuous
• Temperature Compensation

INSTRUMENT TYPE: selective CHA hydrogen analyzer
Designed for the selective determination of hydrogen concentration in multicomponent gas streams using a proton-exchange membrane sensor with a platinum coating, insensitive to the presence of hydrocarbons and aggressive impurities.

• Measured parameters: hydrogen content in gases
• Detector Type: Permeable Platinum Membrane
• Measuring Range: 0/10/100%;
• Accuracy: ± 2% of span
• Response Time: 1-2 minutes typically,
• It is entered in the State registry of SI of the Russian Federation No. 37375-08

SulfurSmart is a high-tech streaming system for the detection and concentration analysis of hydrogen sulfide. The technology combines software algorithms executed by a microprocessor, LED radiation sources, optocouplers, analytical colorimetry and electromechanical drives controlled in a user-friendly interface environment.

• Measured parameters: hydrogen sulfide content in gases
• Метод измерения: фотоколориметрический
• Тип детектора: оптопара
• Соответствие стандартам: ASTM D 4084,
• Диапазон измерения: 0-50/300 ppm; (0-100% с системой разбавления пробы)
• Точность: ±2% от шкалы
• Время цикла измерений: 1-2 мин
• Внесен в Госреестр СИ РФ № 37736-08

• Measurement Range: 0-50 ppm, 0-300 ppm
• Accuracy: ± 1.5 ppm
• Weight: 6.4 kg

Designed for the quantitative determination of hydrogen sulfide in gases, for the rapid determination of hydrogen sulfide content, monitoring the content of
hydrogen sulfide in the air and calibration of flow analyzers of hydrogen sulfide. The measurement principle is rheometric colorimetry on a lead-acetate tape.

The chromatograph is a stationary industrial device that includes a control station (industrial computer), electronic control units, a gas flow control unit (secondary sample preparation system), a sample dispensing device and an analytical unit consisting of a thermostat unit with detectors (up to two detectors) and chromatographic columns (up to eight columns).
The configuration of the complex (type and number of used detectors and chromatographic columns) depends on the nomenclature of the determined components.
To configure and diagnose the operation of the chromatograph, the LAMS software installed
on the built-in computer is used.
On the monitor screen, it is possible to display chromatograms in real time, save chromatograms, view current and archived results of measurements of the content of components, view and edit the parameters of the chromatograph.